08-23-2007 02:29 AM - edited 03-05-2019 06:03 PM
Hi All,
Does anyone know how to change\add a ntp server into the config on a catalyst 500 express switch?
It seems to be going to an internet NTP server by default.
Many Thanks
Andy
08-23-2007 03:34 AM
Hi,
The switch clock is automatically synchronized with the
system clock on your network management station. You can manually set the
system clock settings if the switch should have different time settings.
I hope this helps.
Best regards.
Massimiliano.
08-28-2007 10:17 AM
Task Command
Step 1
Specify the IP address of the NTP server.
set ntp server ip_addr
Step 2
Enable NTP client mode.
set ntp client enable
Step 3
Verify the NTP configuration.
show ntp [noalias]
Regards,
Dharmesh Purohit
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide