Config change records in RME

Unanswered Question
Aug 23rd, 2007
User Badges:

I have archive set up for nightly archiveing of config and it is successful.


Purging of records is set up to maintain 10 versions and not to purge for 26 weeks, but when I look at the version tree, I only see 1 version which is the latest version of the config.


There should be only one directory for configs, what is happeneing to the older versions?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
purohit_810 Thu, 08/23/2007 - 05:19
User Badges:
  • Silver, 250 points or more

Select Resource Manager Essentials > Admin > ChangeAudit > Set Purge Policy.


Here i think you have set default that will be Purge change audit records older than 180 days.



See on below link, performing maintanance TASK:


http://www.cisco.com/en/US/products/sw/cscowork/ps2073/products_user_guide_chapter09186a008035771b.html



Regards,

Dharmesh Purohit

David Stanford Thu, 08/23/2007 - 06:08
User Badges:
  • Cisco Employee,

How often has the config changed on the device? Is it archiving new configs very often?

wilson_1234_2 Thu, 08/23/2007 - 06:44
User Badges:

It is archiving every night.


Some devices the configs to not change often.


Some have changed quite a bit.

Joe Clarke Thu, 08/23/2007 - 07:29
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

A config will not be archived unless an interesting change has occurred. Interesting changes are dictate by those that do not match the exclude commands configured under RME > Admin > Config Mgmt > Exclude Commands.


So, while config archive may be attempted every night, only changed configs will be written to disk, and only they will show up in the version tree.

wilson_1234_2 Thu, 08/23/2007 - 10:40
User Badges:

Thanks for the reply.


I remmember you mentioning that before, but the configs have changed.


That is the thing, on some devices there should be numerous versions and I am only seeing the one.

Joe Clarke Thu, 08/23/2007 - 10:43
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

You should pick one device which does not have its latest config in the archive, and troubleshoot that. Enable ArchiveMgmt Service debugging under RME > Admin > System Preferences > Loglevel Settings, run a Sync Archive job on that device, then look at the dcmaservice.log for any obvious errors.

Actions

This Discussion