ATM

Answered Question

How do I add the following command to a 2811?


interface ATM1/0

description 26HCGJXXXXXX

no ip address

ip nbar protocol-discovery

no atm ilmi-keepalive

no scrambling-payload

Correct Answer by Joseph W. Doherty about 9 years 9 months ago

Is the problem you're not seeing your ATM interfaces? What you might need to do is configure the controller to indicate you're using ATM. Something such as:


controller T1 0/0/0

mode atm aim 0

framing esf

clock source line primary

linecode b8zs

!

controller T1 0/0/1

mode atm aim 0

framing esf

linecode b8zs

!

controller T1 0/1/0

mode atm aim 0

framing esf

linecode b8zs

!

controller T1 0/1/1

shutdown

framing esf

linecode b8zs

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
avmabe Fri, 08/24/2007 - 05:47
User Badges:
  • Bronze, 100 points or more


conf t


paste that in


profit!


assuming, of course, that you have some sort of ATM interface on the 2811. I can't answer that for you as I have never ever used ATM in a 2811.

Correct Answer
Joseph W. Doherty Fri, 08/24/2007 - 08:47
User Badges:
  • Super Bronze, 10000 points or more

Is the problem you're not seeing your ATM interfaces? What you might need to do is configure the controller to indicate you're using ATM. Something such as:


controller T1 0/0/0

mode atm aim 0

framing esf

clock source line primary

linecode b8zs

!

controller T1 0/0/1

mode atm aim 0

framing esf

linecode b8zs

!

controller T1 0/1/0

mode atm aim 0

framing esf

linecode b8zs

!

controller T1 0/1/1

shutdown

framing esf

linecode b8zs

Actions

This Discussion