08-23-2007 07:48 AM - edited 03-03-2019 06:26 PM
How do I add the following command to a 2811?
interface ATM1/0
description 26HCGJXXXXXX
no ip address
ip nbar protocol-discovery
no atm ilmi-keepalive
no scrambling-payload
Solved! Go to Solution.
08-24-2007 08:47 AM
Is the problem you're not seeing your ATM interfaces? What you might need to do is configure the controller to indicate you're using ATM. Something such as:
controller T1 0/0/0
mode atm aim 0
framing esf
clock source line primary
linecode b8zs
!
controller T1 0/0/1
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/0
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/1
shutdown
framing esf
linecode b8zs
08-24-2007 05:47 AM
conf t
paste that in
profit!
assuming, of course, that you have some sort of ATM interface on the 2811. I can't answer that for you as I have never ever used ATM in a 2811.
08-24-2007 08:47 AM
Is the problem you're not seeing your ATM interfaces? What you might need to do is configure the controller to indicate you're using ATM. Something such as:
controller T1 0/0/0
mode atm aim 0
framing esf
clock source line primary
linecode b8zs
!
controller T1 0/0/1
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/0
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/1
shutdown
framing esf
linecode b8zs
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide