cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
810
Views
0
Helpful
1
Replies

QPM 4.0.1 support for 3800 ISR FastEthernet module.

stevek1
Level 1
Level 1

Hi Folks,

I can't define a constraint based on my nm-1fe-2w module in a 3845.

Should this be correct?

Cheers, Steve.

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

Doesn't seem right to me. What version of IOS is the 3800 running? Do the interfaces show up correctly when viewing the device inventory under QPM > Devices > Device Information > Interfaces? If the interface doesn't show up here, and there is no error associated with the device, there may be an SNMP issue collecting inventory for it. Try rediscovering it.

Of course, when defining your constraint, make sure you select the 3800_ISR type. If all else fails, you should be able to define the constraint manually.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: