Berbee-speaker phone

Answered Question
Aug 24th, 2007
User Badges:

Dear All,

We are trying to install Atlas Sound Speaker phone model 18S in Berbee 5.1 but we are unable to do so.

Do we require any firmware files before adding Speaker in Berbee. I have tried to check for the same in C:\ProgramFiles\Berbee\webapp\resources. I was able to find only one file Informacast.cfg

I have tried to enter speaker phone by adding Mac address/speaker name but it is not getting registered ?

can somebody help?



Correct Answer by Chris Deren about 9 years 11 months ago

Perhaps posting your question here:

would help.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Correct Answer
Chris Deren Sat, 08/25/2007 - 16:31
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Perhaps posting your question here:

would help.


cyoungblut Thu, 08/30/2007 - 07:11
User Badges:

Aman - We installed some Atlas Zone Controllers and had similar problems getting those registered. We installed the firmware updates from Berbee (contact them direct) and they seem to register consistently now. I didn't find any info anywhere about firmware updates until I asked them specifically about it.


This Discussion