Management Interaface IPS 4240

Unanswered Question
Aug 25th, 2007
User Badges:

The management interface of IPS 4240 is disabled by default can anyone tell me how to enable this interface.

I hv just done the basic setup and not able to access the IPS through Web browser

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rodrigo Gurriti Sun, 08/26/2007 - 07:40
User Badges:

management interfaces are disabled by default and they always are


on the cisco ips run

setup and once you setup an Ip for the ips you will be able to connect to the web interface


here is a example of how a command-control should look like

ex:

name: FastEthernet0/1

-----------------------------------------------

media-type: tx

description:

admin-state: disabled

duplex: full default: auto

speed: auto

alt-tcp-reset-interface

-----------------------------------------------

none

-----------------------------------------------

-----------------------------------------------

-----------------------------------------------

subinterface-type

-----------------------------------------------

none

-----------------------------------------------

-----------------------------------------------

-----------------------------------------------

-----------------------------------------------

-----------------------------------------------

command-control: FastEthernet0/1

bypass-mode: auto

interface-notifications

-----------------------------------------------

missed-percentage-threshold: 0 percent

notification-interval: 30 seconds

idle-interface-delay: 30 seconds



as you see they are "protected" so you cannot change the state from disable to enable


ram_hiwale Sun, 08/26/2007 - 21:30
User Badges:

Hi,

Thnx for the solution but i already tryed this its not happening, is there anything like need to open the web server port or allowed ip address to access the web innterface.

Actions

This Discussion