Management Interaface IPS 4240

ram_hiwale · ‎08-25-2007

The management interface of IPS 4240 is disabled by default can anyone tell me how to enable this interface.

I hv just done the basic setup and not able to access the IPS through Web browser

Rodrigo Gurriti · ‎08-26-2007

management interfaces are disabled by default and they always are

on the cisco ips run

setup and once you setup an Ip for the ips you will be able to connect to the web interface

here is a example of how a command-control should look like

ex:

name: FastEthernet0/1

-----------------------------------------------

media-type: tx

description:

admin-state: disabled

duplex: full default: auto

speed: auto

alt-tcp-reset-interface

-----------------------------------------------

none

-----------------------------------------------

subinterface-type

-----------------------------------------------

none

-----------------------------------------------

command-control: FastEthernet0/1

bypass-mode: auto

interface-notifications

-----------------------------------------------

missed-percentage-threshold: 0 percent

notification-interval: 30 seconds

idle-interface-delay: 30 seconds

as you see they are "protected" so you cannot change the state from disable to enable

ram_hiwale · ‎08-26-2007

Hi,

Thnx for the solution but i already tryed this its not happening, is there anything like need to open the web server port or allowed ip address to access the web innterface.

mhellman · ‎08-27-2007

You are using HTTPS right, and not just HTTP?

HTTPS://