Nat Misses and Nat slowness

Unanswered Question
Aug 25th, 2007

Currently we have a dynamic nat rule and three static nat rules. Whenever the static routes are enabled, Lan users experience long route seek times, takes a long time for a page to actually start loading. Using show ip nat statistics, Hits:4644285 Misses: 70410. Are these misses related to this problem? If not is there a recommended fix to the problem? Thanks in advanced

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
webmedia07 Mon, 08/27/2007 - 07:31

interface Vlan1

description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$$ES_LAN$$FW_INSIDE$

ip address 192.168.123.1 255.255.255.0

no ip redirects

no ip unreachables

no ip proxy-arp

ip nat inside

ip virtual-reassembly

ip route-cache flow

ip tcp adjust-mss 1452

ip http server

ip http authentication local

ip http secure-server

ip http timeout-policy idle 60 life 86400 requests 10000

ip nat inside source list 1 interface FastEthernet4 overload

ip nat inside source static tcp 192.168.123.50 22 interface FastEthernet4 22

!

webmedia07 Mon, 08/27/2007 - 07:36

Standard IP access list 1

10 permit 192.168.123.0, wildcard bits 0.0.0.255 (253 matches)

webmedia07 Mon, 08/27/2007 - 08:10

I found something interesting today. The cisco router is using the interface FastEthernet3 which has no cable attached into it. We only have FastEthernet4 attached with a cable to the Lan. I searched throughout all of the cisco's config files and interface FastEthernet3 does not show up as an interface for traffic. Is this normal?

crcastillojr Mon, 09/10/2007 - 10:23

I am haing the same problem too. If anyone finds a solution, please let me know.

Actions

This Discussion