08-26-2007 11:58 PM
We have a router which is configured with few site-to-site VPN tunnels.
Recently we have got new IP block and wish to use it for the tunnel establishment.
Is it possible to achieve this on the same router. That is, can I use two different IP addresses on the same router to establish the tunnel.
08-27-2007 02:46 AM
Hi,
Yes, this is very much possible. While configuring the VPN you need to specify the interface to which the tunnel belong to and the peer ip address. You have to select the respective interface for the IPSEC traffic to flow.
Regards,
SH.
08-27-2007 03:11 AM
How do I specify that?
Please note that I am creating a IPSec Tunnel with a crypto map applied on the outgoing interface.
08-27-2007 03:28 AM
Hi,
In your case the outgoing interface will the interface on which the second ISP link was terminated.
SH.
08-27-2007 04:20 AM
The tunnel is not being established from the same router as the one where the ISP link is terminated.
That router is different than the VPN router. There is only one interface which interacts with the Internet router.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide