08-28-2007 09:44 AM - edited 07-03-2021 02:33 PM
I have some 7921 phones. I am trying to connect them using a 4404 wlc on firmware 4.1.181.0
I can connect using wep, but it wont authenticate using wpa2. I have tested the ssid with my laptop and it works, but with the phone it isnt even hitting the radius server.
Any suggestions?
Solved! Go to Solution.
08-28-2007 11:32 PM
Will want to use version 1.03.
Also for WPA2, will need to set the phone to either EAP-FAST or AKM mode. AKM mode will use LEAP for 802.1x. EAP-TLS and PEAP are not supported currently on the Cisco 7921G.
If using EAP-FAST, may want to increase the 802.1x timeout on the controller. See http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/relnote/rn7921_3.htm#wp161964.
08-28-2007 10:23 AM
also on the phone:
App Load ID CP7921G-1.0.2.LOADS
Boot Load ID BL-P203-6065E201
WLAN Driver id is 5.0.0.96
WLAN Firmware ID 4.1.0.80
08-28-2007 11:32 PM
Will want to use version 1.03.
Also for WPA2, will need to set the phone to either EAP-FAST or AKM mode. AKM mode will use LEAP for 802.1x. EAP-TLS and PEAP are not supported currently on the Cisco 7921G.
If using EAP-FAST, may want to increase the 802.1x timeout on the controller. See http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/relnote/rn7921_3.htm#wp161964.
08-29-2007 07:28 AM
Thanks,
That resolved all my issues!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide