08-28-2007 09:44 AM - edited 07-03-2021 02:33 PM
I have some 7921 phones. I am trying to connect them using a 4404 wlc on firmware 4.1.181.0
I can connect using wep, but it wont authenticate using wpa2. I have tested the ssid with my laptop and it works, but with the phone it isnt even hitting the radius server.
Any suggestions?
Solved! Go to Solution.
08-28-2007 11:32 PM
Will want to use version 1.03.
Also for WPA2, will need to set the phone to either EAP-FAST or AKM mode. AKM mode will use LEAP for 802.1x. EAP-TLS and PEAP are not supported currently on the Cisco 7921G.
If using EAP-FAST, may want to increase the 802.1x timeout on the controller. See http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/relnote/rn7921_3.htm#wp161964.
08-28-2007 10:23 AM
also on the phone:
App Load ID CP7921G-1.0.2.LOADS
Boot Load ID BL-P203-6065E201
WLAN Driver id is 5.0.0.96
WLAN Firmware ID 4.1.0.80
08-28-2007 11:32 PM
Will want to use version 1.03.
Also for WPA2, will need to set the phone to either EAP-FAST or AKM mode. AKM mode will use LEAP for 802.1x. EAP-TLS and PEAP are not supported currently on the Cisco 7921G.
If using EAP-FAST, may want to increase the 802.1x timeout on the controller. See http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/relnote/rn7921_3.htm#wp161964.
08-29-2007 07:28 AM
Thanks,
That resolved all my issues!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: