WLC User erased

Answered Question
Aug 28th, 2007

If i erased the privilege user in a wlc 4404 and i just have a user with read-only privileges how can I get more privileges or created a new user with write privileges?

Correct Answer by Stephen Rodriguez about 9 years 6 months ago

If you removed the user that had RW privileges from the WLC, you wither need to have a WCS setup so you can push a new Local Management User down to the WLC, or you would have had to have it setup to do TACACS, feature in 4.1 and better, and then you could get in and add a local account as well.


If you removed the RW user, and do not have the ability to either of the two above, then you need to console into the WLC, and issue Recover-Config after a clean boot, and start over.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Stephen Rodriguez Thu, 08/30/2007 - 08:56

If you removed the user that had RW privileges from the WLC, you wither need to have a WCS setup so you can push a new Local Management User down to the WLC, or you would have had to have it setup to do TACACS, feature in 4.1 and better, and then you could get in and add a local account as well.


If you removed the RW user, and do not have the ability to either of the two above, then you need to console into the WLC, and issue Recover-Config after a clean boot, and start over.

Actions

This Discussion

 

 

Trending Topics - Security & Network