cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
345
Views
0
Helpful
3
Replies

WLC User erased

If i erased the privilege user in a wlc 4404 and i just have a user with read-only privileges how can I get more privileges or created a new user with write privileges?

1 Accepted Solution

Accepted Solutions

Stephen Rodriguez
Cisco Employee
Cisco Employee

If you removed the user that had RW privileges from the WLC, you wither need to have a WCS setup so you can push a new Local Management User down to the WLC, or you would have had to have it setup to do TACACS, feature in 4.1 and better, and then you could get in and add a local account as well.

If you removed the RW user, and do not have the ability to either of the two above, then you need to console into the WLC, and issue Recover-Config after a clean boot, and start over.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

3 Replies 3

Rob Huffman
Hall of Fame
Hall of Fame

Hi Alejandro,

I'm not sure if I am understanding this correctly, but maybe you could just add this user as a Lobby Ambassador with Read-Write privledges.

http://www.cisco.com/en/US/products/ps6366/products_configuration_guide_chapter09186a008082d6b0.html#wp1048412

Hope this helps!

Rob

Stephen Rodriguez
Cisco Employee
Cisco Employee

If you removed the user that had RW privileges from the WLC, you wither need to have a WCS setup so you can push a new Local Management User down to the WLC, or you would have had to have it setup to do TACACS, feature in 4.1 and better, and then you could get in and add a local account as well.

If you removed the RW user, and do not have the ability to either of the two above, then you need to console into the WLC, and issue Recover-Config after a clean boot, and start over.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Thank u, I have a WCS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: