08-29-2007 06:20 AM - edited 03-03-2019 06:30 PM
Hi,
I have an MPLS connectivity between two branches. I have created a tunnel between two router interfaces.
I would like to configure priority queining on the Tunnel interface. (with acl defined priority groups high/medium/low/normal)
Is there a way to do the configuration. i.e configuring priority queing on the Tunnel interface.
Regards
Ravi
08-29-2007 06:41 AM
Hi Ravi,
a tunnel interface does not allow queueing, because it has no hardware queue. What you could do is using hierarchical policies applied to the tunnel interface. Have a look at this other post for more detailed explanations:
A second option is to apply queueing to the hardware interface and use either paket markings (IP precedence, DSCP) or QoS pre-classify.
Hope this helps! Please rate all posts.
Regards, Martin
08-29-2007 06:47 AM
Hi,
CBWFQ is not supported on Tunnel interfaces, but you can use nested policy-maps though.
[edit] Sorry Martin didn't see your reply.
HTH,
Mohammed Mahmoud.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide