Problem with POS interface initialization

Unanswered Question
Aug 29th, 2007

Hi all,


I got a problem when trying to configure IP address in a POS interface that will receive a new link STM1. This interface is new, that is, it never worked before.


After installing it, the router recognize it normally (see below)


!

interface POS6/0

no ip address

shutdown

no cdp enable

!


...but when I configure the ip address, the router stucks in such a way I have to restart it, removing then, the card.


Has anyone seen such a behavior?


The command "show ver" follows below. Any help will be greatly appreciated.


Thanks a lot!


Gustavo


show ver


show version

Cisco IOS Software, 7200 Software (C7200-IS-M), Version 12.3(7)T3, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2004 by Cisco Systems, Inc.

Compiled Tue 20-Jul-04 03:30 by eaarmas


ROM: System Bootstrap, Version 12.2(4r)B2, RELEASE SOFTWARE (fc2)

BOOTLDR: 7200 Software (C7200-KBOOT-M), Version 12.1(14)E6, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)


ufv uptime is 18 hours, 13 minutes

System returned to ROM by power-on

System restarted at 17:23:11 UTC Tue Aug 28 2007 System image file is "disk0:c7200-is-mz.123-7.T3.bin"


Cisco 7206VXR (NPE400) processor (revision A) with 229376K/32768K bytes of memory.

Processor board ID 31783703

R7000 CPU at 350MHz, Implementation 39, Rev 3.3, 256KB L2 Cache

6 slot VXR midplane, Version 2.7


Last reset from power-on


PCI bus mb0_mb1 has 600 bandwidth points PCI bus mb2 has 480 bandwidth points


3 FastEthernet interfaces

18 Serial interfaces

1 Packet over SONET interface

125K bytes of NVRAM.


47040K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).

8192K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2102

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion