4402 Wireless Controller Supported AP's

Unanswered Question
Aug 29th, 2007
User Badges:

Even though the main page says "25 access points supported" I cannot register more than 12. Where do I find the licensing information please?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
ericgarnel Wed, 08/29/2007 - 11:04
User Badges:
  • Gold, 750 points or more

Do you have both ports 1 & 2 plugged in and enabled? Also, are the switch ports set in trunking mode?

p21 Thu, 08/30/2007 - 01:18
User Badges:

There is only one port on the controller connected to the network. That switch port is set to trunk. Thanks.

ericgarnel Thu, 08/30/2007 - 06:18
User Badges:
  • Gold, 750 points or more

The remaining APs will register when you hook up the other port

p21 Thu, 08/30/2007 - 07:43
User Badges:

What is involved? Do I need to enable spanning tree, assign another AP manager IP address etc?

ericgarnel Thu, 08/30/2007 - 07:50
User Badges:
  • Gold, 750 points or more

Configure the port on the switch to trunk in dot1q encap and remove any vlans that will not be needed on the wireless network.

The default settings on the WLC should be fine.

You will have to go into each dynamic interface on the WLC and set the other port as the secondary, if not set already

p21 Thu, 08/30/2007 - 07:59
User Badges:

Thanking you. I will give that a try.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode