08-29-2007 08:56 AM - edited 07-03-2021 02:33 PM
Even though the main page says "25 access points supported" I cannot register more than 12. Where do I find the licensing information please?
08-29-2007 11:04 AM
Do you have both ports 1 & 2 plugged in and enabled? Also, are the switch ports set in trunking mode?
08-30-2007 01:18 AM
There is only one port on the controller connected to the network. That switch port is set to trunk. Thanks.
08-30-2007 06:18 AM
The remaining APs will register when you hook up the other port
08-30-2007 07:43 AM
What is involved? Do I need to enable spanning tree, assign another AP manager IP address etc?
08-30-2007 07:50 AM
Configure the port on the switch to trunk in dot1q encap and remove any vlans that will not be needed on the wireless network.
The default settings on the WLC should be fine.
You will have to go into each dynamic interface on the WLC and set the other port as the secondary, if not set already
08-30-2007 07:59 AM
Thanking you. I will give that a try.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide