08-29-2007 10:48 AM - edited 02-21-2020 01:39 AM
I have two ASA5520s, both running 7.2(3) in an Active/Standby cluster. Since moving them to 7.2(3) it appears to me that the Standby unit is leaking 100kb of memory every hour; it was up for 5 days and suddenly started complaining about being out of memory, while the Primary's Used Memory was holding steady.
Anybody else seeing this? I have a TAC case open, but they don't know of any leaks in 7.2(3)
09-05-2007 06:26 AM
Check the command - logging flash-bufferwrap is configured. Because it sometime cause the memory blog and remove the command if configured.
09-11-2007 12:08 PM
From TAC: "This issue is due to CSCsj97241. This bug covers 80 Byte Block depletion with
stateful failover."
09-11-2007 03:08 PM
FYI
I have a stand-alone ASA 5540 and since upgrading to 7.2(3) I see increasing memory usage through-out the day.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: