EAP type not configured

Unanswered Question
Aug 29th, 2007
User Badges:

hi


i have an ACS 1113 ....


i have installed and configured the certificate... and trusted the CA certificate... also i configured the global authentication (enable the PEAP ,EAP-TLS)


no when i try to authenticate (by the wireless) i get failed to authenticate


when checking the ACS failed attempts i find the failure code

- EAP type not configured-


i don?t know why its happing....

but every thing is configured...


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jagdeep Gambhir Wed, 08/29/2007 - 17:18
User Badges:
  • Red, 2250 points or more

Please make sure on ACS > Network Access Profiles >


Make sure we have "Grant access using global configuration,when no profile matches" option

selected.


Also make sure on ACS > ACS Certificate Setup > Install ACS Certificate >


Make sure a certificate is installed, if it is installed then click cancel.


Also go to ACS > System Configuration > Global Authentication Setup > Make sure under "PEAP" we have checked "Allow EAP-MSCHAPv2" and/or "Allow EAP-GTC" as applicable.



Regards,

~JG

mirboukai Thu, 08/30/2007 - 00:35
User Badges:

thank you

the "Grant access using global configuration,when no profile matches" option was not selected.


could you please give me a brief of why do we configure the NAP..

Actions

This Discussion