cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
589
Views
0
Helpful
2
Replies

4404 WLC stuck in boot loop after upgrade

cchitwood1
Level 1
Level 1

In prepping for the upgrade to 4.1.185.0 I've got two controllers at different sites stuck in a boot loop after applying 4.0.219.0. Units will not even get to the <ESC> option menu.

ANy ideas?

2 Replies 2

dsweeny
Level 3
Level 3

Did you clear the configuration on the controller by using Option 5 in the boot menu? This will corrupt the boot image. You should not choose the clear config (option 5) from the boot menu on controllers running 3.2.78.0, 3.2.116.21, 3.2.150.6 or 3.2.150.10, 3.2.171.5 or 3.2.171.6, 4.0.155.5 or 4.0.179.8 and 4.0.179.11.

No, did not clear the config.

Cisco TAC has verfied the unit is now a boat anchor and has shipped a replacement. They are doing a n autopsy on theold unit to see what the problem is.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: