Configuring RSPAN with CIGESM & 6509

Unanswered Question
Aug 29th, 2007

I'm trying to configure a RSPAN session to monitor traffic on a port on a Cisco IGESM module to a probe on a trunk port on a 6509. The following config has been applied but no traffic is not being seen on the 6509 port or the reflector port.

I have a set a relector port on the CIGESM module and assigned a new VLAN as below:

interface GigabitEthernet0/19

description REFLECTOR PORT FOR RSPAN MONITORING, DO NOT USE/ADJUST

switchport trunk native vlan 100

switchport mode trunk

switchport nonegotiate

CIGESM1_Apollo_Hall2#sh monitor session 1

Session 1

---------

Type : Remote Source Session

Source Ports :

Both : Gi0/10

Reflector Port : Gi0/19

Dest RSPAN VLAN : 100

The following is the config of the 6509 port:

interface GigabitEthernet2/45

description Compuware Probe

switchport

switchport trunk encapsulation dot1q

switchport mode trunk

no ip address

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion