08-30-2007 03:44 PM - edited 03-14-2019 11:18 PM
I seem to be having some problems with using CUE on the remote site. This is my setup
Site A <--- H323 ---> Site B
Both sites are running their own CUE respectively and the H323 trunk works as I am able to dial the remote site's extension number. However, when no one answers and it is forwarded to voicemail, I seem to get a busy tone. Any ideas? The VM works when from the same site and from external calls.
Solved! Go to Solution.
09-02-2007 03:53 PM
Hi Alex,
This sounds like a Codec mismatch problem, CUE only supports g.711. Have a look at this recent thread with some really excellent answers from Brandon;
Hope this helps!
Rob
PS: nice to see you back Paolo (did you have a nice vacation I hope :)
09-02-2007 11:47 AM
Hi,
do you have allow connections h323 to sip in the configuration ?
Hope this helps, please rate post if it does!
09-02-2007 03:43 PM
Yup. This is already in the configuration....
09-02-2007 03:53 PM
Hi Alex,
This sounds like a Codec mismatch problem, CUE only supports g.711. Have a look at this recent thread with some really excellent answers from Brandon;
Hope this helps!
Rob
PS: nice to see you back Paolo (did you have a nice vacation I hope :)
08-04-2008 10:34 AM
Hi All,
I have the same issue, but in my case there is no busy signal from CUE, actually when I call from site A to site B and nobody answers the call in site B, CUE picks the calling number from site A as susbscriber for voicemail and it says "there is not voicemail associated with that user". Also I configure "mailbox-selection orig-called-number" in the voicemail dial-peer, but still it picks caller number as subscriber. any suggestion would be very appreciated.
thanks
Alex
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: