service-policy issue in 4503

Answered Question
Aug 31st, 2007
User Badges:

I have a strange problem with a service-policy in a 4503. I set up the policy to rate limit all traffic with DSCP AF21 to 8 Mbps. However when I apply the configuration instead of give me 8 Mbps it rates limit the matching traffic to 200kbps or something very low around this number. To get around 2 Mbps I needed to change the configuration of the policy to conform 60Mbps!

The policy match perfectly the traffic (other traffic not matching is not affected and I can see the matches in the policy). I guess I am missing something but I cannot find it. I am doing exactly what the documentation says (well I guess so). Any ideas?



Correct Answer by markmckie about 9 years 9 months ago

Change the burst rate to something higher.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Correct Answer
markmckie Sun, 09/02/2007 - 01:15
User Badges:

Change the burst rate to something higher.


This Discussion