Problem with FXO ports

Unanswered Question
Aug 31st, 2007
User Badges:

I connected some PSTN lines on FXO port which are on a EVM-HD-8FXS/DID module on a cisco router 3825. But when a call comes from outside it does not ring on the phone of the operator. The outgoing call are well routed through the FXO ports.

This is the command I put on each FXO port:


voice port 2/0/8

connection plar opx 4094


When I connect an analog phone on the PSTN line, it rings. The phone of the operator works very well.


What could be the problem ?


Can someone help ?


Regards,


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
yatisspor Fri, 08/31/2007 - 06:51
User Badges:

Did you write any dial-peer for these calls? For examle;

dial-peer voice 100 voip

destination-pattern 4094

session target ipv4:"CM ip"

implementation_ipt Fri, 08/31/2007 - 08:05
User Badges:

Hi,

The incoming calls are coming from the PSTN lines. I tried your command but it does not work. Please find in attached the config of my router.


Thanks in advance !



Attachment: 

Actions

This Discussion