08-31-2007 02:57 AM - edited 03-14-2019 11:19 PM
I connected some PSTN lines on FXO port which are on a EVM-HD-8FXS/DID module on a cisco router 3825. But when a call comes from outside it does not ring on the phone of the operator. The outgoing call are well routed through the FXO ports.
This is the command I put on each FXO port:
voice port 2/0/8
connection plar opx 4094
When I connect an analog phone on the PSTN line, it rings. The phone of the operator works very well.
What could be the problem ?
Can someone help ?
Regards,
08-31-2007 04:47 AM
Can you provide more of your config? I'm assuming you're running CME?
08-31-2007 08:07 AM
08-31-2007 06:51 AM
Did you write any dial-peer for these calls? For examle;
dial-peer voice 100 voip
destination-pattern 4094
session target ipv4:"CM ip"
08-31-2007 08:05 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: