didyap Thu, 09/06/2007 - 07:04

For split tunnel you need to configure an ACL and mention the IP address of the remote network to which the traffic is to be encrypted. Then apply this ACL using crypto map's match address statement. Following links may help you

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a008073b06b.shtml#config

http://www.cisco.com/en/US/products/hw/routers/ps274/products_configuration_example09186a0080819289.shtml#config

Actions

This Discussion