cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
943
Views
0
Helpful
3
Replies

PIX subinterface and "switchport mode" conflict

hws_admin
Level 1
Level 1

I created a subinterface on a PIX-515E (7.2.2) but I cannot arping it unless I set the switch port to "switchport mode trunk".

But then the main interface on the PIX stops working, failover claims the status of the main interface is "unknown" and the firewall does not pass traffic.

Set the port back to "switchport mode access", the firewall starts working fine again, but the subinterface is not accessible anymore.

Any suggestions?

3 Replies 3

purohit_810
Level 5
Level 5

Port bydefault been in access mode, if you have configured it in TRUNK that need to give access command otherwise don't.

See in attachment how can you use the same command:

hostname(config-if)# interface ethernet 0/1

hostname(config-if)# switchport mode trunk

hostname(config-if)# switchport trunk allowed

Regards,

Dharmesh Purohit

It doesn't work.

BTW, switch is 2960

Configure these two commands on the 2960 switchport that connects to the PIX and try.

switchport trunk encapsulation dot1q

switchport mode trunk

HTH

Sundar

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: