09-01-2007 07:08 AM - edited 07-03-2021 02:34 PM
Gentlemen,
I have WLC with 3 accesspoints, all them are shown in wlc and their status enable and REG, my problem is the users can associate only with one access point but they can't associate to the others ???
* Note :
in GUI - Security - AP Policies - authorized AP - there is only ONE I added the other 2 later but the same results.
Any idea ASAP,
Thanks
09-03-2007 12:56 PM
so your 3 access pooint are asociated corectly if they show the REG estatus, now check the security parameters in the WLAN TAB.
09-03-2007 10:24 PM
Thanks friends,
I found the problem.
The problem is I enabled WLAN Override and I didn't check any SSID , So I disabled it in the APs and now it works normaaly,
Good Luck,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: