cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
905
Views
0
Helpful
5
Replies

CCM 6.0 + CUE 3.01 CTI-Route Point is not registerd

david.raasch
Level 1
Level 1

Current setup:

CCM: CM6.0.1.2004-4

CUE: AIM module, 3.01

Task completed so far

1. AXL web service activated

2. CTI RP for VM added

3. 6 CTI ports added

4. Add a Application User and add them CTI Route-Point and CTI Ports enable rights

Problems:

1. CTI route point "not registered" status as shown on CM

2. CTI Port is registered

3. JTAPI subsystem registered

I reboot the CCM and the CUE module. No change.

I can import Users from the CCM.

Any Idee what I can do?

Thanks David

5 Replies 5

Hi,

sorry but both link didn`t resolve my issue.

I couldn`t understand why the CTI Ports are registered, but the CTI-Route Point not. For me both will be triggered by the JTAPI User.

David

I have the same issue, in my scenario the 6 cti port and the cti route point dont register... but from the cue web interface i can import users and i see the 6 cti port in "cti port" menù. do you solve the issue?

Hi.

I had an issue like that with CCM 5 and CUE 3.1.1.

It resolved after restarting the CUE.

HTH,

Alex

Hello all,

Yes I faced the same problem CTI Route Point was not registered however CTI Ports were Registered. Reloaded CUE and it got registered.

Thank you and Regards,

Jawwad

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: