Unanswered Question
Sep 3rd, 2007


We ve a 10 mb internet line.But we want to allot a 5mb for a particular IP.We r using 3845 router.How can we configure this using traffic shpe command and how to know 5 mb is getting or not?pls help

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
gaurav_thapar79 Tue, 09/04/2007 - 12:00

Hi, you can not segregate te traffic on per application basis on router. Its possible to limit the traffic generated by spefic IP address used in LAN towards WAN bandwidth. The ACL can be created for single IP address and rate-limit can be defined in policy-map. This policy mao would then control the up/down traffic for single/specific set of IP addresses.

Please try and share your feedback

sanuchakkalayil Tue, 09/04/2007 - 20:50


Actually our bandwidth upgraded from 10 Mb to 30 Mb.The cable from MUX is directly connected to our 3845 router Gigabyte interface.Is there any setting in interface to receive 30 Mb?

This is the configuration .I want to allott 20Mb for tht paricular IP.Is it correct?

traffic-shape group 105 20000000 20000000 20000000 1000

traffic-shape group 106 20000000 20000000 20000000 1000

access-list 105 permit ip host

access-list 106 permit ip any host


This Discussion