09-04-2007 02:29 AM - edited 03-11-2019 04:06 AM
I want to know is it possible to configure this firewall so that the inside and outside interface are configured on the gigabit port modules rather than on board ?
Does anyone knwo if this is possible or any problems i may run into ?
09-04-2007 04:06 AM
you can name any interface 'inside' or 'outside' and assign any security level to any interface.
so yes, it's possible.
09-04-2007 06:03 AM
Is there any documentation for this, all i know is that i will need to change the security of the interfaces but is there anything else
09-05-2007 12:59 PM
Tons, you should receive a 'getting started manual' with it, read that and after go to cisco.com, specifically here and go into security, select OS version, blah blah....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: