09-04-2007 07:15 AM - edited 03-03-2019 06:35 PM
Hello,
I've a cisco 2611 router what shows the following output during the boot (and it's looped). I tried to enter to rommon, but I couldn't. Is there any procedure to recover the system?
System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)
Copyright (c) 2002 by cisco Systems, Inc.
C2600 platform with 98304 Kbytes of main memory
device does not contain a valid magic number
boot: cannot open "flash:"
an alternate boot helper program is not specified
(monitor variable "BOOTLDR" is not set)
and unable to determine first file in bootflash
loadprog: error - on file open
boot: cannot load "tftp:c2600-advsecurityk9-mz.124-13d.bin"
Thanks your help in advance
bye
FCS
09-04-2007 09:14 PM
09-06-2007 06:15 AM
Hello All,
I successfully resolved this booting issue, the procedure was the following:
I try to reseat the memory modules but it didn't solved the booting loop in next step I remove the interface card result was same finally I unmount the network modulo too ( so all modular things were remved). And during the boot the router caught the Ctrl+Break key sequence and went to rommon, whe the cards were installed it didn't recognize Ctrl+Break. After it IOS upload using tftp.
And now the router is up and running.
Bye
FCS
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: