Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2266
Views
0
Helpful
1
Replies

VRRP Configuration

rumhyvarghese
Level 1
Level 1

‎09-04-2007 11:39 PM - edited ‎03-03-2019 06:36 PM

Good Day Sir,

I have two Cisco 2800 Series routers and would like to configure VRRP on these two routers on the LAN interfaces. Is it required to have an additional IP address for VRRP? Both these routers are connected to only ONE switch which in turn connects to our LAN. Please do guide me with the simplest steps in configuring VRRP.

Thanking you in anticipation,

Rumhy Varghese

Labels:
0 Helpful
1 Reply 1

mohammedmahmoud
Level 11
Level 11

‎09-05-2007 12:05 AM

Hi Rumhy,

Yes you need the virtual IP address of the VRRP group:, the simplest configurations is on both router:

interface fastethernet 0/0

ip address x.x.x.x

vrrp 1 ip y.y.y.y <-- Virtual group IP address, which you should use as the default gateway of your LAN

For more details:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hiap_c/ch20/haipvrrp.htm

HTH,

Mohammed Mahmoud.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card