Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
653
Views
0
Helpful
5
Replies

Gigabit connector

Go to solution
peter.mark
Level 1
Level 1

‎09-05-2007 06:49 AM - edited ‎03-05-2019 06:17 PM

What is the command to determine if/or what type of connector is attached to a gigE Interface on a 3560 switch?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
avmabe
Level 3
Level 3
In response to peter.mark

‎09-05-2007 08:36 AM

This is what mine says:

Auto-duplex, Auto-speed, link type is auto, media type is Not Present

Let me know if this helps!

View solution in original post

0 Helpful
5 Replies 5

Go to solution
avmabe
Level 3
Level 3

‎09-05-2007 07:19 AM

What do you mean "What type of connector"?

Are you talking about the RJ-45 ports or the SFP slots?

If you are talking about the SFP slots a "show int" will tell you.

Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseSX SFP

or

Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP

0 Helpful

Go to solution
peter.mark
Level 1
Level 1
In response to avmabe

‎09-05-2007 07:49 AM

It's an SFP connector.

If the connector was not attached would the media type be blank?

0 Helpful

Go to solution
avmabe
Level 3
Level 3
In response to peter.mark

‎09-05-2007 08:36 AM

This is what mine says:

Auto-duplex, Auto-speed, link type is auto, media type is Not Present

Let me know if this helps!

0 Helpful

Go to solution
peter.mark
Level 1
Level 1
In response to peter.mark

‎09-05-2007 09:38 AM

Thanks, that answer my question.

0 Helpful

Go to solution
avmabe
Level 3
Level 3
In response to peter.mark

‎09-05-2007 09:39 AM

Happy to help!

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card