E1 RPI incoming calls problem

Unanswered Question
Sep 5th, 2007

I have configured E1 on 3825 router, the outgoing is ok from all the 40 extensions but when some one tries to call the incoming number that is 8020xxx there is a dial tone on the other side and if we press the extesion number manually 123 the call gets routed to the proper extension, why is it the ccall is not going to the destination in first place

please reply asap

cheers

aamir

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dgoodwin Wed, 09/05/2007 - 08:51

Without knowing the full details of the setup, I am guessing that the 3825 is not configured to expect the full number to arrive in the Setup message... that is the default behavior.

On the first POTS dial-peer which contains the E1 PRI's voice port, add the command direct-inward-dial and see if that solves the problem.

aamirdhedhi Wed, 09/05/2007 - 09:01

Thaks for the reply please find the attached configuration and reply

thanks

controller E1 0/0/1

pri-group timeslots 1-31

interface Serial0/0/1:15

no ip address

encapsulation ppp

no logging event link-status

no snmp trap link-status

isdn switch-type primary-net5

isdn incoming-voice voice

!

dial-peer voice 101 pots

description E1 PRI to PSTN

destination-pattern .T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

incoming called-number .

no digit-strip

direct-inward-dial

port 0/0/1:15

Actions

This Discussion