E1 connection between router 3745 and siemens central

mostafamossad · ‎09-05-2007

i have customer need to make E1 connection between siemens pbx and 3745 router

so i need the part number for the module i need on router 3745 and on the siemens central it self and i need to know if there any considration i must know

i hope any one answer me as fast as he can

paolo bevilacqua · ‎09-05-2007

For the router, you need VWIC-1MFT-E1 or VWIC2-MFT-E1/T1 and AIM-VOICE-30.

For the PBX, ask siemens.

Then the constrains depends on what you are trying to do.

Hope this helps, please rate post if it does!

mostafamossad · ‎09-05-2007

thank u for helping but i need to know what is the function of the AIM-VOICE-30 and why i need it

paolo bevilacqua · ‎09-06-2007

It's a DSP, that is the hardware that converts voice into IP packets and vice-versa.

As an appreciation to those providing answers, please rate useful posts using the scrollbox below!

t.silva · ‎09-06-2007

The AIM-VOICE-30 has a limited support for high-complexity voice codecs (G.729, G.723.1 etc). It support up to 16 concurrent calls that use these codecs.

If you need full support - 30 calls for E1 or 24 calls for T1 - you will need a NM-HDV or a NM-HDV2 module.

Take a look at these URLs to mount your solution: http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_installation_guide_chapter09186a008007c8ea.html

Regards,

paolo bevilacqua · ‎09-06-2007

True, but you can install two modules if needing 30 high-complexity calls.

For complete information there is to say however that some user were disappointed with the features of the AIM-VOICE-30, so the NM-HDV2 with PVDM2 can be a better choice as it uses newer DSP technology.