cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
671
Views
0
Helpful
2
Replies

C4507R power supply problem

qilin zhang
Level 1
Level 1

hi

i have a C4507R with two PWR-C45-1400DC.

Now the two power supplies can run ,the leds on it are all green,but system can't recognize the two power supplies . so that the power for the line card is not enough."show power " is list :

Power Fan Inline Supply Model No Type Status Sensor Status ------ ---------------- --------- ----------- ------- ------- PS1 Unknown Type Unknown good good n.a. PS2 Unknown Type Unknown bad/off bad/off n.a. Power supplies needed by system : 1 Power supplies currently av

what is the problem ? thanks very much

1 Accepted Solution

Accepted Solutions

lgijssel
Level 9
Level 9

Most likely the hardware is not recognized by the supervisor. Checking the release notes I found that you need to run IOS version 12.2(25)EW or newer for this power supply:

http://www.cisco.com/en/US/products/hw/switches/ps4324/prod_bulletin0900aecd801e524a.html

regards,

Leo

View solution in original post

2 Replies 2

lgijssel
Level 9
Level 9

Most likely the hardware is not recognized by the supervisor. Checking the release notes I found that you need to run IOS version 12.2(25)EW or newer for this power supply:

http://www.cisco.com/en/US/products/hw/switches/ps4324/prod_bulletin0900aecd801e524a.html

regards,

Leo

thanks Leo

I've solved the problem by upgrading the IOS .

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: