fxo problem

Unanswered Question
Sep 6th, 2007

i have customer connect make voip between 2 pbx the problem is occure in a specefic site where usually when the users in that site make voip call to another site and finish the call the fxo still up and don't close untill i reset it

do u think it a hardware problem or software problem

i attached the configuration so plz read it if u can and till me is it hardware or configuration problem

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Thu, 09/06/2007 - 05:36


this is the FXO disconnect problem. However, the call showul close after a certain time, which IOS are you using ?

The document that explains the issue is:


Note: in most countries the only configuration you can use is TONE DISCONNECT DETECTION, other tecniques won't work.

Hope this helps, please rate post if it does!

vanbergehenegouwen Thu, 09/06/2007 - 09:20

Why did you put this upon the voice ports? :

supervisory disconnect dualtone mid-call

supervisory custom-cptone dis

Pure for testing?


This Discussion