signnaling on outbound call

Unanswered Question

Hi,

have

CCM on 4.2.3srb

GW MGCP E1 ios 124.6T2

issue

on normal operation, user dial out 11 digits to reach outside. on ip phone we have the correct display of dialed number(11digits). we're discarded the first digits on route list before call going to pstn. we have an alerting tone, but when the call is connected, we have the number prefixed with two supplementary zero. in finally we have 4 zero . Does

anyone has solution?

on srst mode

no problem.

many thanks for advance

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gogasca Thu, 09/06/2007 - 18:27

What if also at Route Pattern level you discard those first digits.?

To resume

For outbound call, users first dial 0 to get E1.

No digits manipulation on route pattern. discarded predot is made on route list to remove the first digit "0" to reach outside.Ex users dials 00130276768

When you hear alerting tone, the display of ip phone is correct "00130276768"

when the remote users answer and call connected, display on ip phone is "0000130276768" instead "0130276768".

on srst mode H323 gateway everything is ok

best reagards

Actions

This Discussion