09-07-2007 12:17 AM - edited 03-15-2019 04:55 AM
Hi all,
I have a question about the Cisco IP Communicator. Is it possible to push (via http) XML to a IP Communicator?
I've got a application that pushes xml to a specific IP Phone (http://IP_ADRES/CGI/Execute), but i recieve an error when it pushes to a IP Communicator: (405) Method Not Allowed
It sounds logic to me because the IP Communicator is running on my Laptop so I'm pushing the xml to my Laptop and directly to the phone device.
Is it somehow possible to push xml to a IP Communicator?
Thanks in advance!
09-07-2007 06:17 AM
Yes, we do it all the time.
The only problem you may run into, is when you have another application on the same laptop, which is using port 80. Then when you push, it can go to that app, instead of phone and you might get an error as the other web server will refuse the connection or give you file not found error.
09-07-2007 06:26 AM
Thanks... I've also IIS running on the same machine, i'll shut it down and test again!
edit:
it works :-)
09-07-2007 10:23 AM
Great. You may want to rate the post.
04-22-2008 08:08 AM
Hi !
I've the same problem with my CISCO IP COMMUNICATOR.
I shut down IIS Web Server, and now, nothing is listening on the 80 port.
How could I specify to the IP Communicator, to listen on it?
Please, help me, i still have this error message : "Can't reach address ..." or "Error 405" when IIS is running.
04-23-2008 12:22 AM
Do you start the IPC before or after shutting down IIS?
If it's before.. that's your problem.. the IPC disables its webserver if something uses port 80.
Also, in ccmadmin, you can configure for each phone whether the built-in webserver should be active or not.. so if it's turned off.. that would also explain why you never see the webserver even when IIS is not running.
04-24-2008 01:28 AM
I started IPC after shutting down IIS and after a system reboot.
Now, when I take a look with NETSTAT -an, there is no process listening on the port 80.
My IPC web server is still down.
I didn't found in CCMADMIN the way to configure the built-in webserver. Where can I found this ?
Perhaps it will solve my problem...
Thanks in advance.
04-24-2008 03:50 AM
Hi again.
I found the problem.
Actually, it was a REGEDIT KEY which has been modified.
HERE IS HOW TO ACTIVATE THE IP COMMUNICATOR WEB SERVER :
START > EXECUTE > REGEDIT
Go to the following KEY :
HKLM > SOFTWARE > Cisco System, Inc. > Communicator
CREATE A NEW DWORD KEY :
"WebServerDisabled" and PUT "0" in value (0x00000000(0) value).
TO DISABLE AGAIN IP COMMUNICATOR WEB SERVER :
You need to put a NON ZERO value to the "WebServerDisabled" key. (for example, put "1" (0x00000001(1) value).
Please, rate this post if it helps someone to solve such problem. Thanks.
04-24-2008 04:18 AM
In CCM6, the parameter is called "Web AccessRequired" and it's in the
Product Specific Configuration Layout
section (at the bottom of the phone config)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide