09-07-2007 12:19 AM - edited 03-05-2019 06:20 PM
Hello
I need little help, becouse I don t understand when I configure port security on switch, do I need to use
switchport mode access and then
switchport port-security something
or I can use just 2 line,
when I should use first line
thx
09-07-2007 12:26 AM
switchport mode access may answer an expert please.
Talking about port-security from my point of view you need an explicit line
switchport port-security
beside the other commands
switchport port-security something1
switchport port-security something2
Otherwise port security is configured but not enabled.
Juergen
09-07-2007 12:27 AM
Hi Friend,
By default switchports are in dynamic desirable mode and port security can only be configured on static access ports or trunk ports. A secure port cannot be a dynamic access port.
That is the reason it is required for you to configure 1st line and then come down to 2nd line of your config.
HTH
Ankur
*Pls rate all helpfull post
09-07-2007 01:12 AM
thx
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: