E1 Software loop

Unanswered Question
Sep 7th, 2007
User Badges:

Hello,


I have a VWIC-2MFT-E1 on a 2800 router.

I have to set up a software loop on the router to check the two E1 links (channelized). Would someone know how to set up a soft loop to test the E1 links.


Regards.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (2 ratings)
Loading.
paolo bevilacqua Fri, 09/07/2007 - 02:21
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

All the loop command are configured under controller. You can loop the line toward the circuit, the router, etc.


Hope this helps, please rate post if it does!

cisco_lad2004 Fri, 09/07/2007 - 02:42
User Badges:
  • Gold, 750 points or more

I vaguley remember the commands, try below:


Controller E1 X/Y

E1 N loopback local



HTH


Sam

deephazz02 Fri, 09/07/2007 - 09:00
User Badges:

Conf t > Controller E1 X/Y/Z > loopback local line

Actions

This Discussion