09-07-2007 02:15 AM - edited 03-03-2019 06:39 PM
Hello,
I have a VWIC-2MFT-E1 on a 2800 router.
I have to set up a software loop on the router to check the two E1 links (channelized). Would someone know how to set up a soft loop to test the E1 links.
Regards.
09-07-2007 02:21 AM
All the loop command are configured under controller. You can loop the line toward the circuit, the router, etc.
Hope this helps, please rate post if it does!
09-07-2007 02:42 AM
I vaguley remember the commands, try below:
Controller E1 X/Y
E1 N loopback local
HTH
Sam
09-07-2007 09:00 AM
Conf t > Controller E1 X/Y/Z > loopback local line
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide