09-07-2007 11:23 AM - edited 03-14-2019 11:26 PM
I am provisioning a 3800 series router with VIC-4FXS/DID and want to use MGCP to connect to CallManager. The Telco is two-wire ground start so my card will supply -48V DC for signalling and Telco will ground-start my line and Touch-Tone in last 4 digits of DID number. I have 25 DID on this circuit (actually it is a group of 6 DID Tip/Ring circuits).
Is MGCP supported for this and does anyone have configuration or am I forced to use H.323 and if so same question?
Thanks. kj7radio1
09-07-2007 11:31 AM
MGCP does not support the VIC-4FXS/DID when used in DID mode. You will need to set it up as H323 signaling.
the following doc for 2600/3600 routers works for the 2800/3800s as well. I have used it many times.
09-07-2007 11:42 AM
Hmmm...wrong card though wrong router. Looked at the document and is referring to VIC-DID. I have VIC-4FXS/DID. Config might work but wondering if this newer card with proper IOS would in fact support MGCP with CallManager.
kj7radio1
09-07-2007 12:56 PM
Config for the VIC-4FXS/DID in DID mode is the same as VIC-DID. MGCP does not support analog DID with either card. H323 is required.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: