09-07-2007 01:31 PM - edited 03-05-2019 06:21 PM
Hi,
i have multiple DSL lines, and doing load balance over all the lines, i.e.
route 0.0.0.0 0.0.0.0 Dilaer1
route 0.0.0.0 0.0.0.0 Dilaer2
and so on,
i would like to route SSL traffic to only one dialer, any idea where to start?
thank you.
09-07-2007 11:49 PM
Directing a particular type of traffic to a certain interface is typically done using policy routing:
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009481d.shtml
Looks like this is the way to go for you as well
regards,
Leo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: