09-10-2007 07:38 PM - edited 03-14-2019 11:28 PM
Is there a difference with regards to supervisory disconnect tone on FXO using H323 gateway and MGCP gateway?
Problem is... Have this setup were supervisory disconnect tone works on MGCP gateway while not working on h323 gateway.
Same telco provider. Recorded and checked the disconnect tone and both same freq and cadence.
Same router platform and ios version.
both H323 and MGCP gateways is connected on the same CCM.
FXO's are used for outgoing calls only.
Setup:
IP phone---ccm5.0.4----3845(ios 12.4(9)T2)-----PSTN.
Configs:
voice class custom-cptone test
dualtone busy
frequency 480 620
cadence 500 500
dualtone disconnect
frequency 480 620
cadence 250 250
:
voice-port 3/0/1
supervisory disconnect dualtone mid-call
supervisory custom-cptone test
no battery-reversal
timeouts call-disconnect 0
timeouts wait-release 1
timing hookflash-out 50
caller-id enable
Attached is the running config and the disconnect tone recorded in case my interpretation of the freq and cadence is wrong.
Appreciate any help i can get.
Thanks!
09-14-2007 01:32 PM
send me the following debugs from the gateway for a failed call.
debug vpm signal
debug mgcp packet
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide