09-11-2007 04:17 AM - edited 03-03-2019 06:42 PM
hi
we have a requirement where in we need to run GRE tunnel over a frame-relay point-to-point to link i need questions to the following.
1.Can we configure GRE tunnel over a Frame-relay point-to-point link
2.What is the minimum router requirement
3.Sample configuration of GRE
Thanks in advance.
/\/agesh.
09-11-2007 04:28 AM
Nagesh
I have not done this exactly as you describe so I can not speak from experience. But it should be easy to do.
I believe that any router that supports point to point Frame Relay will also support GRE tunnels. they have been supported in IOS for a very long time.
The configuration would look something like this (details would obviously depend on your situation):
interface tunnel 1
ip address
tunnel source serial1/1.200
tunnel destination
HTH
Rick
09-11-2007 04:39 AM
thnx rick
will check this up and post the results
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: