Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
908
Views
0
Helpful
2
Replies

GRE over Frame relay

nagesh
Level 1
Level 1

‎09-11-2007 04:17 AM - edited ‎03-03-2019 06:42 PM

hi

we have a requirement where in we need to run GRE tunnel over a frame-relay point-to-point to link i need questions to the following.

1.Can we configure GRE tunnel over a Frame-relay point-to-point link

2.What is the minimum router requirement

3.Sample configuration of GRE

Thanks in advance.

/\/agesh.

Labels:
0 Helpful
2 Replies 2

Richard Burts
Hall of Fame
Hall of Fame

‎09-11-2007 04:28 AM

Nagesh

I have not done this exactly as you describe so I can not speak from experience. But it should be easy to do.

I believe that any router that supports point to point Frame Relay will also support GRE tunnels. they have been supported in IOS for a very long time.

The configuration would look something like this (details would obviously depend on your situation):

interface tunnel 1

ip address

tunnel source serial1/1.200

tunnel destination

HTH

Rick

HTH

Rick
0 Helpful

nagesh
Level 1
Level 1
In response to Richard Burts

‎09-11-2007 04:39 AM

thnx rick

will check this up and post the results

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card