09-11-2007 04:42 AM - edited 03-14-2019 11:28 PM
Hi All
CME 4 with Bri connection takes about 20 seconds to establish an outgoing call via BRI.
Where do I start to diagnose problem?
Port setup as follows:
interface BRI0/2/0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn static-tei 0
isdn skipsend-idverify
normal dial-peer with 9T setup for outgoing calls.
Thanks in advance
09-11-2007 05:04 AM
How you interdigit timeout is set ?
09-11-2007 05:18 AM
We're pressing # to complete the call.
09-11-2007 05:24 AM
Please add "isdn sending-complete" under interface. If no change, please send the usual debug isdn q931, preceded by a "show clock" at the time you press #.
Does it happens with all the numbers ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: